Yaskawa Z1000U HVAC Matrix Bypass - Manual (Page 99)

u Drive Cover Removal
Follow the procedures below to remove and reattach the drive covers for wiring.
u Drives in Bypass Models D024 to D114 and B011 and B124
n Removing the Terminal Cover
1.
Loosen the terminal cover screw.
Figure 3.21 Removing the Terminal Cover
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.22 Removing the Terminal Cover
n Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Input Circuit on page
93 and Wiring the Drive Control Circuit Terminal on page 102 for details on wiring.
Reattach the terminal cover after completing the wiring to the drive and other devices.
<1>
Figure 3.23 Reattaching the Terminal Cover
3.5 Control Circuit Wiring
YASKAWA SIEP YAIZ1D 01A Z1000U HVAC MATRIX Drive Bypass Technical Manual 99
3
Electrical Installation