Yaskawa 1000 Series Drive Option - DeviceNet Technical Manual - Manual (Page 59)

9 Input Assemblies (Drive Produces)
YASKAWA ELECTRIC SIEP C730600 43B 1000-Series Option SI-N3 Technical Manual 59
‹ Change of State Response (Vendor Specific Yaskawa Electric (YE) Assy) - 199
(0xC7)
0x22
Option generated busy event. The MEMOBUS/Modbus requested operation is in the process loop but the drive is not done yet.
Writing “Enter” when drive is running.
Attempt to write data that is read only.
Attempt to write a constant when drive is running.
During a CPF06 event attempting to write to registers other than A1-00 to A1-05, E1-03, o2-04.
0x23 Attempting to write during a drive undervoltage (Uv) event.
0x24 Attempting to write while the drive is storing data.
Input Instance Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
199
0
Multi-
Function
Input 4
Multi-Function
Input 3
NetCtrl NetRef Fault Reset
External
Fault
Run Rev Run Fwd
1 – – – –
Multi-
Function
Input 8
Multi-
Function
Input 7
Multi-
Function
Input 6
Multi-
Function
Input 5
2 FAULT ALARM READY Speed Agree Reset
REV
Running
ZSP Running
3
NetCtrl
(Status)
NetRef
(Status)
– – – 2nd Motor Uv oPE
4 Output Frequency (Low Byte)
5 Output Frequency (High Byte)
6 Actual Torque (Low Byte)
7 Actual Torque (High Byte)
Parameter Data
Run Fwd
Forward Run command from Network
0: Forward Run command is not from network
1: Forward Run command is from network
Run Rev
Reverse Run command from Network
0: Reverse Run command is not from network
1: Reverse Run command is from network
External Fault
External Fault command from Network
0: External Fault command is not from network
1: External Fault command is from network
Fault Reset
Fault Reset command from Network
0: Fault Reset command is not from network
1: Fault Reset command is from network
NetRef
Reference command from Network
0: Reference command is not from network
1: Reference command is from network
NetCtrl
Run command from Network
0: Run command is not from network
1: Run command is from network
Multi-Function Input 3
Terminal S3 command by Network
0: Terminal S3 command OFF
1: Terminal S3 command ON
Multi-Function Input 4
Terminal S4 command by Network
0: Terminal S4 command OFF
1: Terminal S4 command ON
Multi-Function Input 5
Terminal S5 command by Network
0: Terminal S5 command OFF
1: Terminal S5 command ON
Multi-Function Input 6
Terminal S6 command by Network
0: Terminal S6 command OFF
1: Terminal S6 command ON
Error Code Description