HEIDENHAIN SW 548328-05 - Manual (Page 80)

80 Machine mode of operation
3.3 Mac
h
ine data
Slide display and cycle status
 Upper field: Setting of the override control
 Middle field: Programmed feed rate
 Lower field: Actual feed rate
Slide display with rear-face machining
 If rear-face machining is enabled, the slide number is highlighted in blue.
Spindle display with spindle number, gear range and spindle status
 Upper field: Setting of the override control
 Lower field: Actual speed or spindle position
For all of the spindle displays:
 Spindle symbol: Black means the spindle is enabled; white means it is not.
 Numeral in spindle symbol: Gear range
 Numeral at right next to the spindle symbol: Spindle number
 If a spindle key exists, the number of the selected spindle is highlighted in color.
 Spindle status: See "Spindle" on page 82.
 Display of the programmed speed in rpm or m/min
 Display of the actual speed in rpm
 If M19 is active and the machine tool builder has made the setting, when the
spindle is not turning, the display shows the spindle position instead of the
spindle speed.
 If a spindle is in slave mode during synchronous operation, the value "0" is
displayed instead of the programmed speed.
Spindle display with spindle number, gear range and spindle status
 Upper field: Programmed speed
 Lower field: Actual speed or spindle position
Spindle display with spindle number, gear range and spindle status
 Upper field: Setting of the override control
 Middle field: Programmed speed
 Lower field: Actual speed or spindle position
Override display of the active spindle
 F: Feed rate
 R: Rapid traverse
 S: Spindle
Motor utilization: Utilization of the drive motor with respect to the rated torque
 Digital axis and spindle motors
 Analog axis and spindle motors, if set up by the machine tool builder
Elements of machine data display