HEIDENHAIN SW 548328-05 - Manual (Page 78)

78 Machine mode of operation
3.3 Mac
h
ine data
Machine data display
Elements of machine data display
Position display X, Y, Z, W: Distance between tool tip and workpiece zero point
 A black axis letter means the axis is enabled; white means it is not enabled.
Handwheel active Clamping active
Position display C: Position of the C axis
 Empty box: C-axis is not active
 A black axis letter means the axis is enabled; white means it is not enabled.
Display settings of the position display: Can be set via the
MP_axesDisplayMode user parameter. The setting is shown by a letter next to the
position window.
 A: Actual value (setting: REFIST)
 N: Nominal value (setting: REFSOLL)
 L: Following error (setting: SCHPF)
 D: Distance to go (setting: RESTW)
Display of the slide number and C-axis number: A numeral next to the position
window of the axis shows the assigned slide or C-axis number. The numeral is only
displayed if an axis was configured multiple times, e.g. a second C-axis as opposing
spindle.
Distance-to-go display X, Y, Z, W: The distance remaining from the current
position to the target position of the active traversing command
Distance-to-go and protection zone status: Distance-to-go display and display of
status of protective zone monitoring
Protective zone monitoring
active Protective zone monitoring
not active
Position display for four axes: Display of position values for up to four axes. The
displayed axes depend on the machine configuration.