HEIDENHAIN SW 548328-05 - Manual (Page 203)

HEIDENHAIN MANUALplus 620 203
4.5 Recessing cy
cles
Type of machining for technology database access: contour
recessing
By setting the following optional parameters, you can define
additional contour elements:
 A:Oblique cut at contour start
 W:Oblique cut at contour end
 R:Rounding arc (in both corners of the contour valley)
 B1:Chamfer/Rounding at contour start
 B2:Chamfer/Rounding at contour end
Cycle run
1 Calculate the recess positions and the proportioning of cuts
2 Approach the workpiece for next recess from starting point or from
last recess on paraxial path
3 Move at the programmed feed rate to the contour end point Z2,
or if defined, to one of the optional contour elements
4 Remain at this position for a dwell time of two revolutions
5 Retract and approach for next pass
6 Repeat 3 to 5 until the complete recess has been machined
7 Repeat 2 to 6 until all recesses have been machined
8 Return to starting point on paraxial path
9 Move to the tool change point according to the G14 setting
MFE M at end: M function that is executed at the end of the
machining step
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining