HEIDENHAIN SW 548328-05 - Manual (Page 271)

HEIDENHAIN MANUALplus 620 271
4.6 Thr
ead and under
c
ut cy
cles
Cycle run
1 Pre-position threading tool to center of thread groove
2 Use the Take over position soft key to transfer the tool position
and spindle angle to the parameters measured positions ZC and
measured angle C
3 Move the tool manually out of the thread groove
4 Position the tool in front of the workpiece
5 Start cycle with the Input finished soft key, then press Cycle
START
R Remaining cutting depth only with GV=4
(default 1/100 mm)
Q No. no load (number of dry runs)
MT M after T: M function that is executed after the tool call T
MFS M at beginning: M function that is executed at the
beginning of the machining step
MFE M at end: M function that is executed at the end of the
machining step
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining