HEIDENHAIN SW 548328-05 - Manual (Page 127)

HEIDENHAIN MANUALplus 620 127
4.2 W
o
rk
piece blank cy
cles
ICP workpiece blank contour
Select define the blank
Select ICP workpiece blank contour
The cycle integrates the workpiece blank defined with ICP and
describes the setup used. This information is evaluated during the
simulation.
Cycle parameters
X
Clamp diameter
Z Clamping position in Z
B Clamping range
J Clamp type
 0: Not clamped
 1: Externally clamped
 2: Internally clamped
RK ICP contour number
WP Displays which workpiece spindle is used to process the cycle
(machine-dependent)
 Main drive
 Opposing spindle for rear-face machining
RG Contour follow-up for Teach-in mode
 0: Without contour follow-up
 1: With contour follow-up