HEIDENHAIN SW 548328-05 - Manual (Page 558)

558 Organization mode of operation
8.3 T
ransf
er
Use the cursor keys to select the folder, then press
the Enter key to switch to the right window.
With the cursor keys, select the NC program to be converted.
Mark all NC programs.
Start the import filter for converting the program(s) to
the MANUALplus format.
Converting cycle programs
MANUALplus 4110 and MANUALplus 620 have different solutions for
tool management, technology data, etc. Also, the cycles of the
MANUALplus 620 have more parameters than those of the
MANUALplus 4110.
Please note the following:
 Tool call: The loading of the T number depends on whether the
program is a "multifix program" (2-digit T number) or "turret program"
(4-digit T number).
 2-digit T number: The T number is loaded as "ID" and entered as
the T number "T1".
 4-digit T number (Tddpp): The first two digits of the T number (dd)
are loaded as "ID" and the last two (pp) as "T".
 Moving to the tool change point: In tool change point G14, the
converter enters the "no axis" setting. In the MANUALplus 4110 this
parameter is not used.
 Safety clearance: The safety clearances defined in the "general
settings" parameter are entered by the converter in the safety
clearance G47, ... SCI, ... SCK
.
The names of imported cycle programs, ICP contour
descriptions, DIN programs and DIN subprograms are
given the prefix "CONV_..." In addition, the MANUALplus
adapts the extension and imports the NC programs to the
correct folders.