HEIDENHAIN SW 548328-05 - Manual (Page 141)

HEIDENHAIN MANUALplus 620 141
4.3 Single cut cy
cles
M functions
Machine commands (M functions) are not executed until Cycle start
has been pressed. With the M list soft key you can open an overview
of the available M functions. For the meaning of the M functions, refer
to your machine manual.
Call the single-cut menu
Select M function
Enter the number of the M function
Conclude entry
Press Cycle start
Call the single-cut menu
Select M function
Switch M19 on
Enter the stopping angle
Conclude entry
Press Cycle start
M FUNCTION
SPINDLE STOP M19 (SPINDLE POSITIONING)