HEIDENHAIN SW 548328-05 - Manual (Page 493)

HEIDENHAIN MANUALplus 620 493
7.
3 T
ool data
Recessing tools
Select "New tool."
Select recessing tools.
Recessing tools are used for recessing, parting, recess turning and
finishing (only smart.Turn).
Special parameters for recessing tools
RS
Cutting radius
SW Point angle
SB Cutting width
SL Cutting length
DS Special compensation
SUT Tool type (required for AWG in TURN PLUS):
 0: Recessing
 1: Parting
 2: Recess turning
DN Tool width
SD Shank diameter
ET Maximum plunging depth
NL Usable length
RW Angular offset (only for B axis)
For further tool parameters, see page 489.
The wear compensation DX, DZ compensates for wear on
the two sides of the tool tip that lie next to the reference
point. The special compensation DS compensates for
wear on the third side of the tool tip.