HEIDENHAIN SW 548328-05 - Manual (Page 105)

HEIDENHAIN MANUALplus 620 105
3.9 Pr
ogr
am Run mode
Comparing a tool list
While a program is being loaded, the MANUALplus compares the
current tools in the turret with the tool list of the program. If tools are
used in the program that are not in the current turret list or are located
in another pocket, an error message is displayed.
After the error message is confirmed, the program-dependent tool list
is shown for checking.
You can transfer the programmed tool table with the Load tool soft
key, or cancel the program selection with Cancel.
Before executing a program
Faulty programs
The MANUALplus checks the programs during loading up to the
MACHINING section. If it detects an error (for example, an error in the
contour description), it displays the error symbol in the screen
headline. You can then press the Info key for detailed information on
the error.
The machining section of a program and therefore all traverse is not
interpreted until after Cycle on. If there is an error here, the machine
stops with an error message.
 Testing the cycles and cycle parameters
The MANUALplus displays the Teach-in program or the DIN
program in the list window. With Teach-in programs, the parameters
of the cycle on which the cursor is placed are displayed.
 Graphic control
You can monitor program run with the graphic simulation feature
(see "Simulation mode of operation" on page 460).
Danger of collision!
 Load the programmed tool list only if it matches the
actual turret assignment.
 A program start is not possible unless the programmed
tool list matches the turret list that was set up.
Danger of collision!
Before starting the program, check it in the simulation to
find errors in the programming or the syntax used.