HEIDENHAIN SW 548328-05 - Manual (Page 38)

38 Introduction and fundamentals
1
.3 F
eat
ur
es
1.3 Features
Configuration
 Basic version: X and Z axis, spindle
 Positionable spindle and driven tool
 C axis and driven tool
 Y axis and driven tool
 B axis for machining a tilted plane
 Digital current and speed control
Operating modes
Manual operation
Manual slide movement through axis-direction keys or electronic
handwheels.
Graphic support for entering and running Teach-in cycles without
saving the machining steps in alternation with manual machine
operation.
Thread reworking (thread repair in a second workpiece setup).
Teach-in mode
Sequential linking of Teach-in cycles, where each cycle is run
immediately after input, or is graphically simulated and subsequently
saved.
Program run
All are possible in single-block and full-sequence modes
 DINplus programs
 smart.Turn programs
 Teach-in programs
Setup functions
 Workpiece datum setting
 Definition of tool-change position
 Definition of protection zone
 Tool measurement through touch-off, touch probe or optical gauge
Programming
 Teach-in programming
 Interactive Contour Programming (ICP)
 smart.Turn programming
 Automatic program creation with TURN PLUS
 DINplus programming