HEIDENHAIN SW 548328-05 - Manual (Page 22)

22
4.6 Thread and undercut cycles ..... 253
Thread position, undercut position ..... 253
Handwheel superimposition ..... 254
Feed angle, thread depth, proportioning of cuts ..... 254
Thread run-in / thread run-out ..... 255
Last cut ..... 256
Thread cycle (longitudinal) ..... 257
Thread cycle (longitudinal)—expanded ..... 259
Tapered thread ..... 262
API thread ..... 264
Recut (longitudinal) thread ..... 266
Recut (longitudinal) thread—expanded ..... 268
Recut tapered thread ..... 270
Recut API thread ..... 272
Undercut DIN 76 ..... 274
Undercut DIN 509 E ..... 276
Undercut DIN 509 F ..... 278
Examples of thread and undercut cycles ..... 280
4.7 Drilling cycles ..... 282
Drilling, axial ..... 283
Radial drilling ..... 285
Deep-hole drilling, axial ..... 287
Deep-hole drilling, radial ..... 290
Tapping, axial ..... 292
Tapping, radial ..... 294
Thread milling, axial ..... 296
Examples of drilling cycles ..... 298
4.8 Milling cycles ..... 300
Rapid positioning milling ..... 301
Slot, axial ..... 302
Figure, axial ..... 304
ICP contour, axial ..... 308
Face milling ..... 311
Slot, radial ..... 314
Figure, radial ..... 316
ICP contour, radial ..... 320
Helical-slot milling, radial ..... 323
Milling direction for contour milling ..... 325
Milling direction for pocket milling ..... 326
Example of milling cycle ..... 327
Engraving, axial ..... 328
Engraving, radial ..... 330
Engraving, axial/radial ..... 332