HEIDENHAIN SW 548328-05 - Manual (Page 253)

HEIDENHAIN MANUALplus 620 253
4.6 Thr
ead and under
c
ut cy
cles
4.6 Thread and undercut cycles
Thread position, undercut position
Thread position
The MANUALplus determines the direction of the thread from the
parameters for starting point Z (or current tool position in Manual
mode) and end point Z2. You select internal or external thread by soft
key.
Undercut position
The MANUALplus determines the position of an undercut from the
parameters for starting point X, Z (current tool position in Manual
mode) and cylinder starting point X1/end point Z2 on plane
surface.
The thread and undercut cycles machine single or multi-
start longitudinal and tapered threads, as well as thread
undercuts.
In Cycle mode you can
 Repeat the last cut to compensate for tool inaccuracies.
 Use the Recut function to rework damaged threads
(only in Manual mode).
 Threads are cut with constant rotational speed.
 At a cycle stop, the tool retracts with the spindle still
rotating. The cycle then has to be restarted.
 Feed rate override is not effective during cycle
execution.
Thread and undercut cycles Symbol
Thread cycle
Longitudinal single or multi-start
thread
Tapered thread
Tapered single or multi-start thread
API thread
Single or multi-start API thread (API:
American Petroleum Institute)
Undercut DIN 76
Thread undercut and thread chamfer
Undercut DIN 509 E
Undercut and cylinder chamfer
Undercut DIN 509 F
Undercut and cylinder chamfer
An undercut can only be machined in a right-angled
paraxial contour corner in the linear axis.