HEIDENHAIN SW 548328-05 - Manual (Page 520)

520 Organization mode of operation
8.2 P
a
ra
met
e
rs
Coolant for new units
Default setting for the coolant (start unit: CLT parameter):
 0: Without coolant
 1: Coolant circuit 1 on
 2: Coolant circuit 2 on
Protection zone "G60" for new units
Default setting for the protection zone (start unit: G60
parameter):
 0: Active
 1: Inactive
Global safety clearance G47
Default setting for the global safety clearance (start unit: G47
parameter)
Global safety clearance G147 in the plane
Default setting for the global safety clearance in the plane (start
unit: G147 parameter)
Global safety clearance G147 in infeed direction
Default setting for the global safety clearance in infeed
direction (start unit: G147 parameter)
Global oversize in X direction
Default setting for the global safety clearance in X direction
(start unit: I parameter)
Global oversize in Z direction
Default setting for the global safety clearance in X direction
(start unit: K parameter)
Rotational direction for new units
Default for the spindle direction of rotation MD when creating/
opening a new unit ("Tool" tab)
Front edge of chuck on main spindle
Z position of the front edge of the chuck for calculating the
workpiece zero point (AWG)
Front chuck edge on counterspindle
Z position of the front edge of the chuck for calculating the
workpiece zero point (AWG)
Jaw width on main spindle
Jaw width in Z direction for calculating the workpiece zero point
(AWG)
Jaw width on counterspindle
Jaw width in Z direction for calculating the workpiece zero point
(AWG)
Global safety clearance