HEIDENHAIN SW 548328-05 - Manual (Page 379)

HEIDENHAIN MANUALplus 620 379
5.8 Cont
our elements of a t
u
rn
ing cont
our
Vertical lines
Select the line direction.
Enter the line dimensions and define the transition to the next
element.
In smart.Turn, ICP generates a G1.
Horizontal lines
Select the line direction.
Enter the line dimensions and define the transition to the next
element.
In smart.Turn, ICP generates a G1.
Parameters
X
Target point
Xi Incremental target point (distance from starting point to
target point)
W Polar target point (angle)
P Polar target point (radius)
L Length of line
U, F, D, FP, IC, KC, HC: See machining attributes on page 357
Parameters
Z
Target point
Zi Incremental target point (distance from starting point to
target point)
W Polar target point (angle)
P Polar target point (radius)
L Length of line
U, F, D, FP, IC, KC, HC: See machining attributes on page 357