HEIDENHAIN SW 548328-05 - Manual (Page 188)

188 Cycle programming
4.4 T
u
rn
ing cy
cles
ICP transverse finishing cut
Select cut, longitudinal/transverse
Select ICP cutting, transverse
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour. When
the cycle is completed, the tool remains at the cycle end position.
The tool plunges with the maximum possible angle,
leaving material remaining.
Cycle parameters
X, Z
Starting point
FK ICP finished part: Name of the contour to be machined
DXX Additive compensation number 1 –16 (see page 124)
G58 Contour-parallel oversize
DI Axis-parallel oversize X
DK Axis-parallel oversize Z
SX, SZ Cutting limits (see page 124)
G47 Safety clearance (see page 124)
G14 Tool change point (see page 124)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T