beautypg.com

2 configuration, Slide position, Tool carrier systems – HEIDENHAIN SW 548328-05 User Manual

Page 35: The c axis, 2 configur ation 1.2 configuration

background image

HEIDENHAIN MANUALplus 620

35

1

.2 Configur

ation

1.2

Configuration

In the standard version, the control is equipped with the axes X and Z
and a main spindle. Optionally, a C axis, a Y axis, and a driven tool can
be configured.

Slide position

The machine tool builder configures the MANUALplus. These are the
available possibilities:

Z axis horizontal with tool slide behind the workpiece

Z axis horizontal with tool slide in front of the workpiece

Z axis vertical with tool slide to the right of the workpiece

The menu symbols, help graphics and graphic representations during
ICP and simulation consider the slide position.

The representations in this User’s Manual assume a lathe with tool
carrier behind the workpiece.

Tool carrier systems

The MANUALplus supports the following systems as tool carriers:

Multifix holder with one tool mount

Turret with n tool mounts

Turret with n tool mounts and one multifix holder with a mount.
Here it is possible for one of the two tool carriers to be arranged
mirrored on the workpiece side opposite from the standard tool
carrier.

Two multifix holders, each with one tool mount. The tool carriers are
arranged opposite to each other. One of them is then mirrored.

The C axis

With a C axis you can drill and mill a workpiece on its face and lateral
surfaces.

When the C axis is used, one axis interpolates linearly or circularly with
the spindle in the given working plane, while the third axis interpolates
linearly.

The MANUALplus supports part program creation with the C axis in:

Teach-in mode

smart.Turn programming

DINplus programming

This manual is related to the following products: