HEIDENHAIN SW 548328-05 - Manual (Page 373)

HEIDENHAIN MANUALplus 620 373
5.5 Editing ICP cont
ours
Editing contour elements
The MANUALplus provides various ways to change an existing
contour. The procedure is illustrated in the following example of
editing the length of an element. The other functions work similar to
the procedure described here.
The following editing functions are available for existing contour
elements.
 Trimming
 Length of element
 Length of contour (only for closed contours)
 Radius
 Diameter
 Change
 Contour element
 Form element
 Delete
 Element/Range
 Move element/range as well
 Contour/Pocket/Figure/Pattern
 Form element
 All form elements