HEIDENHAIN SW 548328-05 - Manual (Page 204)

204 Cycle programming
4.5 Recessing cy
cles
Recessing radial, finishing
Call the recessing cycles
Select recessing, radial
Press the Finishing run soft key
The cycle finishes the number of recesses defined in number Qn. The
parameters for starting point and end point of contour define the
first recess (position, recess depth and recess width).
Cycle parameters
X, Z
Starting point
X2, Z2 Contour end point
Qn Number of recess cycles (default: 1)
DX, DZ Distance to subsequent recess with respect to the
preceding recess
G47 Safety clearance (see page 124)
G14 Tool change point (see page 124)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T
MFS M at beginning: M function that is executed at the
beginning of the machining step