HEIDENHAIN SW 548328-05 - Manual (Page 488)

488 Tool and technology database
7.
2 T
ool edit
or
Setting up the holder for manual change systems
Set up the manual change system holder in the turret assignment:
 Select turret assignment: Press the "Turret list" soft
key
 Select an unassigned turret pocket and press the
"Special functions" soft key
 Open the holder table: Press the "Set up holder" soft
key
 Select the holder and press the "Adopt ID no." soft key
Selecting the manual change system in the tool data
Define the tool as a manual change tool in the tool data form:
 Open the tool data form: Press the "Edit" soft key
 On the third form page, select MTS 1: MANUAL CHANGE
TOOL
 Confirm the entry by pressing the "Save" soft key
After setting up a holder for a manual change system in
the turret assignment, the first three fields of the specific
line are color-highlighted.
You can remove a manual change system holder again
with the "Remove holder" soft key.
in the turret assignment you can only set up the holder
type MTS 1 (manual change system). With holder type
MTS 0
(standard holder), the control displays an error
message.
If you define a tool as a manual change system, in the tool
list the tool type field (tool symbol) is color-highlighted.
With manual change tools you must not select a HID tool
holder (empty field). Assignment of holder and tool is
implemented via the turret assignment. A manual change
system has to have been set up on the corresponding
turret pocket for this.
With multipoint tools you must assign the MTS entry value
for all cutting edges equally.