HEIDENHAIN SW 548328-05 - Manual (Page 485)

HEIDENHAIN MANUALplus 620 485
7.
2 T
ool edit
or
Holder table
In the "to_hold.hld" holder table, define the holder type and the tool
setting dimensions of the holder. Because the geometric information
is currently only evaluated with holders of the "manual change system"
type, the management of standard tool holders in the holder table is
not required.
Process holder table in the tool editor:
 Press the "Other tables" soft key
 Open the holder table: Press the "Holder Editor" soft
key
The holder table contains the following entries:
NR Line number
HID ID number: Unique holder name (up to 16 characters)
MTS Manual change system:
 0: Tool holder
 1: Manual change system
ZLH Tool setting dimension in Z
XLH Tool setting dimension in X
YLH Tool setting dimension in Y