Grass Valley Kameleon Series v.5.1.0 - Manual (Page 90)

90 Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
Signal Setup
For 525 standard composite, select Setup to add setup to the output or No
Setup to not add it to the composite output.
Cross Color Removal
Enable Cross Color Removal filtering for a composite signal that displays
unwanted luminance and chrominance artifacts produced during
encoding of the signal.
Chrominance Removal
Enable Chrominance Removal to completely remove the chrominance
portion of the composite output signal.
Burst Removal
Enable Burst Removal to completely remove the burst portion of the com-
posite output signal.
Output Video Adjustments
Gain and coarse/fine delay of the composite output signal can be set to cal-
ibrated values by selecting the
Calibrated button. The delay settings are inde-
pendent of the Frame Sync and SDI Video output controls.
If User Adjustable is selected use the following controls to adjust the com-
posite output:
• Delay Coarse – adjusts the output delay in coarse steps of 5 pixels (double
arrows) or 0.5 pixels (single arrows). The coarse delay range is from
0–4095 pixels.
• Delay Fine – adjusts the percent of output delay in fine steps of 10 percent
(double arrows) o r1.0 percent (single arrows). The fine delay range is
from 0–100% (100% = 37-38 ns)
• Output Video Gain – adjusts the output video gain in steps of 5 percent
(double arrows) or 0.5 percent (single arrows). The output gain range is
approximately 61–138.5 percent.