Grass Valley Kameleon Series v.5.1.0 - Manual (Page 17)

Kameleon Series Instruction Manual 17
Installation
• KAM-AA-R – designed for eight-channel analog audio I/O (see
Table 2 on page 21 ).
• KAM-MIX-R – designed for mixed I/O of two AES/EBU streams
(balanced or unbalanced) and four analog audio channels, (see
Table 3 on page 22 ).
• KAM-AES-R – designed for eight AES/EBU audio, balanced or
unbalanced I/O connections (see
Table 4 on page 24 ). No submod-
ules are used with this application.
• KAM-AA-AES-UR – designed for mixed I/O of three dual balanced
analog audio inputs or outputs (six channels) and four BNC audio
connections for four streams of AES audio inputs, outputs, or two
inputs and two outputs (see
Table 6 on page 26 ). If the sub-
module(s) need to be installed, refer to Figure 5 on page 16 for the
location of the submodule depending on the application.
• KAM-AA-MIX-BR – designed for mixed I/O of four dual balanced
analog audio inputs or outputs (eight channels) and two dual bal-
anced audio connections for four streams of AES audio which can
be set independently as inputs or outputs (see
Table 7 on page 28 ).
If the submodule(s) needs to be installed, refer to Figure 5 on
page 16 for the location of the submodule depending on the appli-
cation and Figure 6 for installing it onto the module.
• KAM-AA-MIX-UR – designed for mixed I/O of four dual balanced
analog audio inputs or outputs (eight channels) and one Sub-D 9
pin connector for four streams of unbalanced AES audio which can
be set independently as inputs or outputs (see
Table 8 on page 30 ).
If the submodule(s) need to be installed, refer to Figure 5 on page 16
for the location of the submodule depending on the application.
To install a submodule, line up the connectors on the bottom of the sub-
module with the correct submodule position on the top of the media
module circuit board (
Figure 6 ). Press firmly to seat the submodule and
Figure 6 for installing it onto the module.
After power-up, installation status of the submodule will be reported
on the Status web page as described in
Status Web Page on page 46 .
Figure 6. Kameleon Submodule Installation
8173_31r1
Submodule 1
Submodule 2
KAM-ADC/DAC submodule