Grass Valley Kameleon Series v.5.1.0 - Manual (Page 54)

54 Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
Figure 27 illustrates the KAM-AA-MIX-BR Rear module I/O Config web
page. The type of submodule in Position 1 will determine whether Analog
Audio connectors J8 and J9 are inputs or outputs. The submodule in Posi-
tion 2 will determine whether Analog Audio connectors J5 and J6 are
inputs or outputs.
AES balanced connectors J3 and J4 can be defined as inputs or outputs with
the pulldown controls on this I/O web page. Refer to
Table 6 on page 26 for
submodule I/O combinations.
There are two identical SDI video outputs at connectors J1 and J2.
Note If the KAM-AA-MIX-BR Rear module is installed in a frame with a 2000NET
module running version 3.2.2 or earlier software, the dual Analog and AES
audio graphics will be shown as boxes with red X’s. Functionality is not
affected. This rear module requires 2000NET software 4.0.0 or later to recog-
nize the dual graphics.
Refer to Table 7 on page 28 for submodule I/O combinations and Figure 14
on page 27 for cabling information.
Figure 27. KAM-AA-MIX-BR Rear Module I/O Configuration Web Page