Grass Valley Kameleon Series v.5.1.0 - Manual (Page 112)

112 Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
Slot Configuration Web Page
Use the Slot Config web page ( Figure 76 on page 114 ) to:
• Assign an appropriate name to the module slot,
• Assign an Asset Tag identification,
• Enable/disable the Locate Module function,
• Save module configuration and enable slot memory, and
• Link to the 2000NET Frame Health Reporting and SNMP Reporting
web pages.
Slot Identification
You may identify the module by typing a specific name in the Name field.
The assigned name is stored on the 2000NET module and travels with the
2000NET module if it is moved to another frame. Select
Default to enter the
factory default module name.
An asset identification may be entered in the Asset Tag field. This will appear
on the module Status web page and in the NetConfig inventory report.
Locate Module
When enabled by selecting the Flash pulldown, the Locate Module function
flashes the yellow COMM and CONF LEDs on the front of the module to
make it easy to locate in the frame (see
Operation Indicator LEDs on page 32 ).
Slot Memory
The slot configuration for each media module is automatically saved peri-
odically (once an hour) to the 2000NET module in that frame. You may also
select the
Learn Module Config button at any time to save the current configu-
ration for this slot. The configuration is saved on the 2000NET module. If
the 2000NET module is removed or powered down, the stored configura-
tions are not saved.
When the Restore upon Install box has been checked, the current configuration
saved to this slot is saved as slot memory. When the current module is
removed and another module of the same type and software version is
installed, the configuration saved to the 2000NET module will be down-
loaded to the new module. The box must be checked before the current
module with the saved configuration is removed.
If a different type of module is installed in this slot, a warning message will
state that the original module type has been replaced with another module
type. In this case, a
Clear button will appear allowing you to clear the stored
configuration from the previous module.
Note Uncheck the Restore Upon Install button before downloading new software.
Use
this
link