Pair selection, Audio gain, Output processing – Grass Valley Kameleon Series v.5.1.0 User Manual
Page 102: Audio proc web page
102
Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
Audio Proc Web Page
Use the Audio Proc web page (
) to adjust the fol-
lowing for Audio Pair 1 & 2 and Audio Pair 3 & 4:
•
Adjust audio signal gain for each individual channel or the two audio
pairs,
•
Lock gain settings for simultaneous channel A/channel B adjustment,
and
•
Select a processing option for each channel.
Pair Selection
Use the Pair Selection radio buttons to select either Pairs 1 & 2 or Pairs 3 & 4
for adjustment.
Audio Gain
Each audio channel can be adjusted for gain separately or in pairs. Use the
following adjustments for audio gain:
•
To lock the two channels in a pair together, select the Gain Settings
Locked
checkbox for Pair 1 and/or Pair 2.
•
Adjust the gain (-40 to +6 dB) for each channel with the Ch A Gain
Adjust and Ch B Gain adjust controls for each pair. If the pair is locked,
adjusting either control will set the gain to the same value for each
channel in the pair.
Note
After gain has been adjusted, a straight quote mark (') will be added to Ch A'
and Ch B' to indicate the status of the channels after gain.
Output Processing
Set the output processing for each channel with the Processing pulldown to
one of the following:
•
Pass
•
Invert
•
A+B
•
A-B
•
-(A+B)
•
1 kHz (test tone)
•
400 Hz (test tone)
•
Silence
•
A+B (Pairs 1 or 2 and Pairs 3 or 4) - the sum of the opposite pair.
Use
this
link