Grass Valley Kameleon Series v.5.1.0 - Manual (Page 33)

Kameleon Series Instruction Manual 33
Configuration and Adjustments
Configuration and Adjustments
KAM-AV/SD configuration and monitoring can be performed using a web
browser GUI interface or a networked Newton Control Panel. This section
provides an overview of each of these controls along with the configuration
parameters available with each type of control device.
Configuration Summary
The configuration parameters and monitoring functions available with the
web browser interface and the Newton Control Panel are summarized in
Table 10 . The parameter defaults, choices, ranges, and resolution are pro-
vided for each function
Table 10. Summary of KAM-AV/SD Configuration Controls
Function Default
Range/Choices
Resolution
Web Page/
Function Name
Newton
Panel
Module/
Submodule
Composite video in 100%
44 to 219.5%
(0.5% steps)
Composite In/
Input Video Gain%
IVidGain
KAM-AV
only
Black level 0%
–21.6 to 22.4%
(0.1% steps)
Composite In/
Black Level%
BlackLVL
Input signal setup (525 only) Setup No Setup or Setup
Composite In/
Input Signal Setup
No Setup or Setup radio button
N/A
3D motion type Mixed Motion
Low Motion
Mixed Motion
High Motion
Composite In/
3D Decoder Control
Low Motion, Mixed Motion or
High Motion radio button
N/A
3D motion threshold
Low – 60
Mixed – 25
High – 5
0 to 127
(1 unit steps)
Composite In/
3D Decoder Control
3D Motion Threshold
MotThrld
3D Comb filter Luma + Chroma
Luma + Chroma
Luma
Chroma
Composite In/
3D Decoder Control
Comb Filter pulldown
decmodeL
3D Luma bandwidth
Low – Wide
Mixed – Wide
High – Narrow
Narrow or Wide
Composite In/
3D Decoder Control
Luma Bandwidth
Narrow or Wide radio button
LumaBw
3D Luma level 56
0 to 255
(1 unit steps)
Composite In/
3D Decoder Control
Luma Level control
YLevel
3D Chroma level 56
0 to 255
(1 unit steps)
Composite In/
3D Decoder Control
Chroma Level control
CLevel
3D Decoder reset to default
Mixed Motion
Defaults
–
Composite In/
3D Decoder Control
Reset 3D Decoder to Default button
N/A
Blank VBI lines (Field 1 and
Field 2)
Pass Through
Blanking, Notch
Decode, Pass
Through, and Remove
setup (525 mode)
VBI Decode/
VBI Line radio buttons
N/A KAM-AV/SD