Grass Valley Kameleon Series v.5.1.0 - Manual (Page 85)

Kameleon Series Instruction Manual 85
KAM-AV and KAM-SD Links and Web Pages
VBI Encode Web Page for Composite Output
Use the VBI Encode web page ( Figure 54 for 525, Figure 55 on page 86 for
625 line rate) to configure the VBI and Data Line encoding for the com-
posite output signal (KAM-AV module only).
The currently detected line rate will be reported. Use the View Selection to
view the web page at the correct line rate with the
525 or 625 radio button.
This web page allows you to do the following on a line-by-line basis:
• Blank existing VBI and Data Line information
• Remove black level setup (in 525 line rate only)
You may also apply the clipping done in the Video Processor to all VBI lines
by checking the
Apply Clips to VBI/Data Lines checkbox.
Note The data lines not reserved for carrying data on the Video Input Select web
page will appear greyed out. See
Advanced VBI Configuration on page 72 .
Figure 54. VBI Encode Web Page – 525 Line Rate
Use
this
link
Data lines configured in
Advanced VBI view on
Video Input Select web page