Grass Valley Kameleon Series v.5.1.0 - Manual (Page 113)

Kameleon Series Instruction Manual 113
KAM-AV and KAM-SD Links and Web Pages
Frame Health Reports Link
Select the Frame Health Reports link to open the 2000NET module Frame
Alarm Reporting web page. This web page allows configuration of what
alarms and warnings are reported to the external Frame Health Alarm con-
nector on the rear of the 2000T3 frame only.
Note This link will not appear when the module is installed in a 2000T1 frame.
This web page contains the following sections:
• Hardware Switch Status – the Hardware Switch Status section of this web
page displays the current settings of the alarm and warning configura-
tion DIP switches, S1 and S2, on the 2000NET circuit board in this
frame. These switches allow enabling and disabling of what overall
status reporting information is provided to the external Frame Alarm.
• Output Format for Warnings – set the Output Format for Warnings on the
external RS-232 Frame Alarm output on the rear of the frame. When the
Open radio button is selected, warnings are not reported to the external
frame alarm. Selecting the Closed radio button, causes warnings to be
reported in the same manner as alarms.
• Frame Health Reporting – this section provides a table showing the pres-
ence and status of all frame devices such as modules, power supplies,
and fans and other frame functions such as Module Health and Frame
Bus status. Use the corresponding
Report checkboxes to indicate which
alarms and warnings should be reported to the Frame Health alarm for
the following conditions:
• Faults
• Signal Loss
• Reference Loss
• Config Error