Grass Valley Kameleon Series v.5.1.0 - Manual (Page 20)

20 Kameleon Series Instruction Manual
Installation
Cabling
All cabling is done at the corresponding rear module. Six different rear
modules are available for various audio and video I/O configurations.
All modules accept SDI video in and provide SDI video out. Composite
video inputs and outputs are only available with the KAM-AV front
module.
Many audio functions require the use of the audio ADC (analog to digital)
and DAC (digital to analog) conversion submodules installed on the front
module. Use of the submodules depends on the type of rear module and
the audio requirements as described in each rear module cabling section.
Cabling for each type of rear module is illustrated in the figures listed
below:
• KAM-AA-R – see Figure 10 on page 21 ,
• KAM-MIX-R – see Figure 11 on page 22 ,
• KAM-AES-R – see Figure 12 on page 23 ,
• KAM-AA-AES-UR – see Figure 13 on page 25 ,
• KAM-AA-MIX-BR – see Figure 14 on page 27 , and
• KAM-AA-MIX-UR – see Figure 15 on page 29 .
Specific signal names are assigned for each connector using the 2000 GUI
using the
I/O Config web page (see Configuration and Adjustments on page 33 ).