Grass Valley Kameleon Series v.5.1.0 - Manual (Page 80)

80 Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
MUX Web Page
Use the MUX (multiplex) web page to:
• Delete unwanted audio groups from the SDI input video signal or clear
all horizontal ancillary data (HANC), and
• Insert or replace audio groups into the SDI video stream that have been
selected on the Audio Input Select web page, paired on the Audio
Channel Pairing web page and configured in the Audio Proc, Audio
Sync, and Audio Delay web pages.
Note The audio channel pairs available to each Mux Group below are determined
by the Audio Channel Pairing web page (see
page 100 ).
Note The Kameleon multiplexing circuit assumes there are no gaps between
Groups in the input SDI video signal. If there are gaps, and one or more
groups are inserted or replaced, all input Groups after the gap will be
removed.
The MUX web page provides two functions: Group Deletion and Group
Replacement.
Group Deletion
The Group Deletion area of the MUX web page reports if an embedded
audio signal is present in any of the four possible audio groups in the
incoming SDI signal and the output status of each group. It is the same as
the Status reporting on the DEMUX web page (
Figure 38 on page 68 ). It can
be used to delete unwanted embedded audio groups or clear all HANC
(horizontal ancillary data) in the SDI video input signal if present.
Composite Video Input
When composite video is selected as the input to the module (no embedded
audio is possible), the MUX web page Group Deletion section will appear
as shown in
Figure 47 with the Delete and No Input HANC data to clear greyed
out.
Figure 47. Composite Video Input
Use
this
link