Grass Valley Kameleon Series v.5.1.0 - Manual (Page 30)

30 Kameleon Series Instruction Manual
Installation
Table 8 provides the various audio input and output I/O configurations
and the video outputs for the KAM-AA-MIX-UR rear module. Analog
audio input or output configuration depends on the positioning of the
audio ADC and DAC submodules.
Figure 5 on page 16 illustrates the rela-
tionship of submodule to rear connector for KAM rear modules.
AES/EBU audio input or output configuration is set by configuring the
connector as an input or output on the I/O Config web page (
Figure 28 on
page 55 ).
Any number of audio inputs can be configured but there is a limit of four
audio output pairs with any configuration.
Table 8. KAM-AA-MIX-UR I/O Configurations
Submodule 1
Submodule
2
Video Input
Analog Audio
Inputs/Outputs
1
1 There may be any number of audio inputs but there is a limit of four output audio pairs with any configuration.
AES Audio
Inputs/Outputs
Video Output
A to D A to D
1 SDI or Composite 2
(J10)
2 Only KAM-AV modules support composite video I/O.
4 dual Analog inputs
(J5, J6, J8, and J9)
4 AES/EBU (J3)
unbalanced
streams from break-
out cable indepen-
dently selectable as
inputs or outputs on
I/O Config web page.
2 SDI (J1 and J2),
1 Composite (J7)
2
A to D D to A
2 dual Analog inputs (J8 and J9)
and 2 dual Analog outputs (J5 and J6)
D to A D to A
4 dual Analog outputs
(J5, J6, J8, and J9)
D to A A to D
2 dual Analog outputs (J8 and J9) and
2 dual Analog inputs (J5 and J6)
A to D None 2 dual Analog inputs (J8 and J9)
None A to D 2 dual Analog inputs (J5 and J6)
D to A None 2 dual Analog outputs (J8 and j9)
None D to A 2 dual Analog outputs (J5 and J6)
None None None