Grass Valley Kameleon Series v.5.1.0 - Manual (Page 56)

56 Kameleon Series Instruction Manual
KAM-AV and KAM-SD Links and Web Pages
I/O Config Page Elements
Four of the AES-Rear module audio connectors are shown in Figure 29 to
illustrate the function of each row of the diagram.
Header Row
The top header row provides the connector hardware physical label (J#)
and the dedicated signal type for the connector. This information is deter-
mined by the type of rear module and front processor module installed
(refer to the
Functional View Web Page on page 58 ).
Figure 29. Balanced/Unbalanced AES/EBU Inputs
Connectors
The Connector row illustrates connector type provided (BNC or 3-pin ter-
minal) for each port. Connector type and input/output possibilities vary
according to the rear I/O module used or with the presence of ADC or
DAC submodules.
Input/Output Mode
I/O mode is either static read-only or an operational Input/Output selec-
tion (determined by the rear module used).
Signal Name
Enter a signal name (up to 15 characters) for each operational
input/output. The name will be used to identify the signal in other config-
uration pages.
Signal type
Input/Output Selection
Connector physical label
User input
Select active connector pair:
unbalanced (BNC) or
balanced (3-pin)
Gray sections are not available
Header
Connector
I/O mode
Signal name
Status
8173_30