Grass Valley Kameleon Series v.5.1.0 - Manual (Page 55)

Kameleon Series Instruction Manual 55
KAM-AV and KAM-SD Links and Web Pages
Figure 28 illustrates the KAM-AA-MIX-UR Rear module I/O Config web
page. The type of submodule in Position 1 will determine whether Analog
Audio connectors J8 and J9 are inputs or outputs. The submodule in Posi-
tion 2 will determine whether Analog Audio connectors J5 and J6 are
inputs or outputs.
AES unbalanced connector J3 can be defined as inputs or outputs with the
pulldown controls on this I/O web page.
There are two identical SDI video outputs at connectors J1 and J2.
Note If the KAM-AA-MIX-UR Rear module is installed in a frame with a 2000NET
module running version 3.2.2 or earlier software, the dual Analog and AES
audio graphics will be shown as boxes with red X’s. Functionality is not
affected. This rear module requires 2000NET software 4.0.0 or later to recog-
nize the dual graphics.
Refer to Table 8 on page 30 for submodule I/O combinations and Figure 15
on page 29 for cabling information.
Figure 28. KAM-AA-MIX-UR Rear Module I/O Configuration Web Page