Grass Valley Kameleon Series v.5.1.0 - Manual (Page 122)

122 Kameleon Series Instruction Manual
Specifications
Overall processing accuracy 10 bits
Luma frequency response ± 0.1 dB to 5.5 MHz
Chroma (R-Y,B-Y) response -1.5 dB @ 1.3 MHz
Group delay error < 5 ns to 5.5 MHz
Chroma/luma delay < 10 ns
Luma non-linearity < 0.15%
K factor (2T) < 0.5%
Line tilt < 0.5%
Field tilt < 0.5%
Differential phase < 1 degree
Differential gain < 1%
Signal/noise ratio (CCIR410 or
EIA RS-250B) > 60 dB to 5.5 MHz
Phasing None
Picture centering error 0.0 ±20 ns non-adjustable
Decoding modes Three-line adaptive with two pre-programmed adaption threshold levels high/low
Blanking start/end SMPTE170M or CCIR624, non-adjustable
Composite In Control
Overall video gain range 44% to 219% in 0.5% steps, 100% default
Black range -21.5% to +22% of luma full-scale in 0.1% steps, 0 default
Hue range -180 to + 179 degrees in 0.1 degree steps, 0 degree default (525 only)
Setup processing in vertical Line by line on/off (525 only)
Vertical blanking processing Line by line blank/notch decode/pass
Table 15. Composite Output Specifications
Parameter Value
Composite Output
Number of outputs 1
Signal type Composite analog video conforming to SMPTE170M for NTSC and CCIR624
for PAL-B
Signal level 600 mV to 1.4 V p-p adjustable, 1 V p-p default
Output clamping level 0 VDC ±20 mV
Output impedance 75 Ohm
Connector type 75 Ohm BNC on rear module
Output return loss > 40 dB to 5.5 MHz
Output isolation > 46 dB to 5.5 MHz
Composite Output Performance
Response ± 0.1 dB to 5.0 MHz
Differential phase < 0.5 degrees
Differential gain < 0.9%
Group delay < 10 ns to 5.5 MHz
RMS signal-to-noise > 59 dB to 5.5 MHz
Table 14. Composite Input Specifications
Parameter Value