Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 96)

80
Master Control
Software Configuration
Master Control Configuration Cross-Reference
To use a master control configuration, the main Imagestore 750 configuration must make refer-
ence to it.
Choose ‘Configuration Mode’ in the top right drop-down menu. From the ‘System Settings’ tab,
select
Master Control > Master Control Configuration :
Fig. 5-21: Imagestore Configurator - Configuration Mode
Then select the required master control configuration file from the drop-down list at the right.
Save and apply the configuration, and wait for the Imagestore 750 to restart. The channel
sources and source groups will now be available for the channel processor to use.
Salvo Configuration
Please see Router Salvos on page 64 for an introduction.
 Before a salvo configuration file can be created, at least one system salvo must have been
defined in the NV9000 configuration. Please refer to the NV9000-SE Utilities Users Guide. (See
Applicable Publications and Tools on page 3.)
A salvo configuration file identifies the router salvos that the Imagestore 750 can use. The salvo
configuration file is stored in the Imagestore 750 separately from the main configuration, which
references it.
The following sections describe how to create and edit the Imagestore 750’s salvo configuration.
The salvo configuration file can be shared among different Imagestore 750s.