Master control configuration – Grass Valley Imagestore 750 v.3.0.1 User Manual
Page 88
72
Master Control
Software Configuration
Choose ‘Configuration Mode’ in the top right drop-down menu. Then, choose the ‘System
Settings’ tab and open the ‘Master Control’ branch of the navigation tree at the left:
Fig. 5-3: Imagestore Configurator - Master Control section
1 Specify the router type as NV9000.
2 Enter the IP address on the ‘router address’ field.
This can be a physical IP address (if you have a stand-alone NV9000 system), or a “virtual” IP
address (when you have a redundant NV9000 system). Refer to the NV9000-SE Utilities Users
Guide.
3 Leave the ‘router port’ field as its default.
4 Save and apply the configuration, and wait for the Imagestore 750 to restart.
5 During restart, the Imagestore 750 reads pertinent configuration data from the NV9000.
6 Choose
File
>
Open
and select the Imagestore 750 by its IP address.
7 From the list of all Imagestore 750 configurations, select ‘Active Configuration’ and click OK.
8 Master Control system settings (from the NV9000) are now available to the Imagestore 750
Configurator
It is important to complete these steps before proceeding with other configuration tasks.
The configurator cannot perform certain functions without knowing the NV9000’s IP
address.
Master Control Configuration
on page 63 and
on page 64 for an overview.
Before a master control configuration file can be created, router sources must have been
defined on the NV9000. Please refer to the NV9000-SE Utilities Users Guide. (See
The master control configuration file defines channel sources and source groups that the
channel processor will be able to control and the owning iMC panel(s) will be able to represent