Grass Valley Imagestore 750 v.3.0.1 User Manual
Page 85
69
Imagestore 750
User Manual
NV9000
1 Using the NV9000’s master control network port, connect the NV9000 to the master control
network switch. Assign an IP address to the NV9000’s master control network port. (See
Applicable Publications and Tools
The default IP address is 192.168.7.201 for the primary NV9000’s master control network and
192.168.7.202 for the secondary’s.
If you prefer not to change the NV9000’s master control address, make all other IP addresses
on the master control network part of the 192.168.7.xxx subnet.
Your NV9000 might have been defined with a virtual IP address. It is preferable to use the
virtual IP address if it has one.
Imagestore 750
2 Connect the Imagestore 750 to master control’s Ethernet switch using Ethernet cable. You
can use either of the two LAN ports on the Imagestore 750.
3 Assign an IP address to the Imagestore 750.
Use the front panel menu (
Setup
>
Network
>
IP
Address
).
The IP address must belong to the master control subnet. If necessary assign a gateway
address using the front panel menu (
Setup
>
Network
>
Gateway
Add
).
4 Repeat steps 2 to 4 for additional Imagestore 750s.
Intuition XG
5 Connect the Intuition XG to the master control Ethernet switch using Ethernet cable.
Assign an IP address to the Intuition XG. (Refer to the Intuition XG publications listed under
Applicable Publications and Tools
The IP address must belong to the master control subnet. If necessary, assign a gateway
address.
Repeat this step for additional Intuition XG co-processors, always selecting unique IP
addresses.
iMC Panels
6 Connect the iMC panel to the master control Ethernet switch using Ethernet cable.
Assign an IP address to the iMC panel using its touch screen (
Panel
Settings
>
IP
Setup
>
Change
IP
). The IP address must belong to the master control subnet. If neces-
sary, assign a gateway address.
Repeat this step for additional iMC panels, always selecting unique IP addresses.
Configuration PC
7 Connect a configuration PC to the master control switch and give it an appropriate IP
address on the master control subnet. Also connect a configuration PC to the NV9000 at its
house network port (again with an appropriate IP address). You can use the same PC for
both networks.
At this point, if you have the requisite configuration software installed, it is possible to configure
the Imagestore 750(s), the NV9000, and your control panels.