Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 6)

vi
General Warnings
A warning indicates a possible hazard to personnel which may cause injury or death. Observe
the following general warnings when using or working on this equipment:
• Heed all warnings on the unit and in the operating instructions.
• Do not use this equipment in or near water.
• This equipment is grounded through the grounding conductor of the power cord. To avoid
electrical shock, plug the power cord into a properly wired receptacle before connecting the
equipment inputs or outputs.
• Route power cords and other cables so they are not likely to be damaged.
• Disconnect power before cleaning the equipment. Do not use liquid or aerosol cleaners; use
only a damp cloth.
• Dangerous voltages may exist at several points in this equipment. To avoid injury, do not
touch exposed connections and components while power is on.
• Do not wear rings or wristwatches when troubleshooting high current circuits such as the
power supplies.
• To avoid fire hazard, use only the specified fuse(s) with the correct type number, voltage and
current ratings as referenced in the appropriate locations in the service instructions or on
the equipment. Always refer fuse replacements to qualified service personnel.
• There are no user-serviceable fuses in this equipment. Connection to the mains supply
should be via a circuit breaker or by a mains plug which meets the relevant local standards in
the country of installation.
• To avoid explosion, do not operate this equipment in an explosive atmosphere.
• Have qualified service personnel perform safety checks after any service.
• To avoid electrical shock or fire hazard, do not operate the equipment with its covers
removed.
• To prevent equipment from overheating, provide proper ventilation.
General Cautions
A caution indicates a possible hazard to equipment that could result in equipment damage.
Observe the following cautions when operating or working on this equipment:
• When installing this equipment, do not attach the power cord to building surfaces.
• To prevent damage to equipment when replacing fuses, locate and correct the problem that
caused the fuse to blow before re-applying power.
• Use only the specified replacement parts.
• Follow static precautions at all times when handling this equipment.
• This product should only be powered as described in the manual. To prevent equipment
damage, select the proper line voltage on the power supply(ies) as described in the installa-
tion documentation.
• To prevent damage to the equipment, read the instructions in the equipment manual for
proper input voltage range selection.