Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 54)

38
Features
Keying Graphics
• Any remaining events in the EAS alert ‘off’ GPI macro are processed. These macro events are
suspended until the preceding events complete.
Additional commands can be added to the GPI macros to provide other EAS actions. At a
minimum, these events must include a ‘Voiceover On’ and ‘Voiceover Off’ command and appro-
priate delays to ensure that the data for the crawl is received. Such GPI macros are outside the
scope of this manual, but can be discussed with Miranda Support.
Because the Imagestore 750 retains the last EAS text message received, the EASNone.oxa crawl
will be seen only when the EAS mode is activated with no alert level. When verbose logging is
enabled, all EAS transactions are recorded in the standard Imagestore 750 log files.
Temperature Probe
 The temperature probe feature requires the IS-750-TEMP option.
This option provides a low-cost temperature sensor (Sensorsoft ST6154J) for measuring the
local temperature, typically from the roof of the building. The temperature can be recorded in
Celsius or Fahrenheit, and can be displayed (and continually updated) on a keying layer of the
Imagestore 750 using an Easytext template.
The thermometer connects by cable to an RS-232 serial port of the Imagestore 750 and can be
located up to 1000 feet away without the need for a battery or external power adapter. It has an
external stainless steel probe, suitable for outdoor applications or where liquids are present.
More information is found on the temperature probe option’s instruction sheet. That is Miranda
document M987-9805-101.
Temperature Probe Parts
This table lists the probe parts:
 Note: For pin-outs to be correct at the Imagestore 750, the parts must be connected in the
order listed in the table above.
Temperature Probe Serial Port Settings
Set the probe’s serial port protocol and Baud rate to the following values at the Imagestore 750’s
front panel or in the Imagestore 750 Configurator:
Protocol ST61XX Thermometer
Baud rate 1200
Temperature Probe Easytext Templates
When the Easytext option is enabled, you can use the special temperature probe datasource
names (show in the table below) for text boxes within any Easytext template used on the
Miranda Part Number Description
4100-0041-0 Sensorsoft ST6154J RS-232 temperature sensor with external probe
3503-0024-0 Sensorsoft C2000 cable, DB9-to-RJ45, 20 feet
1897-1700-100 Miranda adapter, RJ45-to-DB9 for RS-232 DTE
0702-1400-100 Ethernet cable, RJ45-to-RJ45 CAT5 UTP, flex 10 feet
Table 4-8: Temperature Probe Parts