Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 232)

216
Gateway Add Gateway address (changed via Setup > Network menu).
MAC Addres MAC address (factory set)
NTP Server NTP server address (changed via Setup > Network menu).
Op System Linux operating system kernel version
File Sys Type File system type for the /home partition (JFS)
Animation Mem Store memory associated with DSK 1
Animation Mem Store memory associated with DSK 2
Animation Mem Store memory associated with DSK 3
Animation Mem Store memory associated with DSK 4
Images Used Number of files in the image library (up to 4000 displayable on the front panel)
Disk Space Used Disk space used, in MB or GB, with percentage of total space used
Current MixFile ‘Audio Graph’ if audio is defined by the Imagestore 750 Configurator. Otherwise, the name of
the mix file
COM 1 Counters “Rx” (received data), “Tx” (transmitted data), “FE” (framing errors), “PE” (parity errors), “BI”
(breaks), “OE” (overrun errors)
COM 2 Counters See “COM 1 Counters” (above)
COM 3 Counters See “COM 1 Counters” (above)
COM 4 Counters See “COM 1 Counters” (above)
RS232 A Counters See “COM 1 Counters” (above). Reserved for future use
RS232 B Counters See “COM 1 Counters” (above). Reserved for future use
RS485 1 Counters See “COM 1 Counters” (above)
RS485 2 Counters See “COM 1 Counters” (above)
RS485 3 Counters See “COM 1 Counters” (above)
RS485 4 Counters See “COM 1 Counters” (above)
Time Zone Time zone offset from GMT (changed via Setup > Date/Time)
Current Date Current date (changed via Setup > Date/Time)
Current Time Current time (changed via Setup > Date/Time)
Running Since Date and time when the unit was last powered up
Main Board Rev Main board revision
I/O Board Rev I/O board revision
DVE Board Rev DVE board revision
Store SPD Store memory Serial Presence Detect (SPD) size and product ID
Delay SPD Delay memory Serial Presence Detect (SPD) size and product ID
CPU FPGA Date Firmware build date
CPU FPGA Ident Firmware mode: “SD” or “HD”
CPU FPGA Version Firmware version number
Operate
Set Inputs
A
Pass SDI Selects incoming SDI input for use by this input
Colour Field 1 Selects Color Field 1 for use by this input (in place of SDI)
Colour Field 2 Selects Color Field 2 for use by this input (in place of SDI)
Colour Field 3 Selects Color Field 3 for use by this input (in place of SDI)
Test Pattern 1 Selects Test Pattern 1 for use by this input (in place of SDI)
Test Pattern 2 Selects Test Pattern 2 for use by this input (in place of SDI)
B
Pass SDI See “A” (above)
Colour Field 1 See “A” (above)
Colour Field 2 See “A” (above)
Colour Field 3 See “A” (above)
Test Pattern 1 See “A” (above)
Test Pattern 2 See “A” (above)