Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 188)

172
Imagestore 750 Configurator
Modes
(See Audio Mix Blocks on page 165.)
Master Control Mode
 This mode is available only when the master control licence ( IS-750-Master-Control ) is
installed.
Master control mode allows you to create and edit the channel sources and source groups that
will permit the inclusion of the Imagestore 750 in an iMC master control system and permit
control of router switching by iMC panels and automation.
To enter ‘Master Control Mode’, select it from the drop-down list at the top right corner of the
Imagestore 750 Configurator. You can then create or edit master control configurations by
selecting ‘File > New’ or ‘File > Open’.
When the configuration is complete, you can save it to the Imagestore 750 by selecting ‘File >
Save’. (See
Saving a Configuration on page 175.)
Go to System settings > Master control > Master control configuration to specify a master control
configuration to use:
Please refer to Master Control Configuration on page 72 for details regarding master control
setup.
Salvo Mode
 This mode is available only when the master control licence ( IS-750-Master-Control ) is
installed.
Salvo mode allows you to create and edit the mapping between router salvo names, which are
retrieved from the NV9000 router control system, and IDs that can be used by automation.
When an iMC panel is connected to the Imagestore 750, it uses salvo IDs to drive salvos in the
NV9000.
To enter ‘Salvo Mode’, select it from the drop-down list at the top right corner of the Imagestore
750 Configurator.
Fig. 8-12: Imagestore 750 Configurator - Salvo Mode
Right-click on the left pane to expose a context menu that allows the following actions to be
performed: