Managing configurations, Saving a configuration, Importing a configuration – Grass Valley Imagestore 750 v.3.0.1 User Manual
Page 191: Saving a configuration importing a configuration, Managing con, Figurations, Saving a, Configuration
175
Imagestore 750
User Manual
Delete
This deletes the selected DVE sequence(s).
Once the configuration is complete, you can save it to the device by selecting ‘File > Save’. (See
Go to
System
settings
>
DVE
>
DVE
Mapping
to specify a DVE mapping preset file to use.
Managing Configurations
Saving a Configuration
When a configuration (or preset) from any of the available configurator modes is completed,
you can save it to one or more Imagestore 750s and create a backup file as necessary. Use the
‘File’ menu as follows:
•
‘File > Save’
Confirm the IP address of the Imagestore 750 and the filename under which to save the con-
figuration.
Subsequent saves reuse the same IP address and filename.
•
‘File > Save As > To Device…’
Confirm the IP address of the Imagestore 750 and the filename under which to save the con-
figuration. This creates a new configuration file.
•
‘File > Save As > To File…’
Make a backup copy of the configuration (to your PC or elsewhere).
You can also copy the current ‘active configuration’ to a file by selecting
User
Presets
>
Export
from the front panel. The configuration filename created is in the format
‘
YYYYMMDD_HHMMSS.xml
’ within the Imagestore 750.
Importing a Configuration
There are two ways to import (or apply) the main system configuration so that it becomes
‘active’ on the Imagestore 750.
The first method uses the Imagestore 750 Configurator:
1 Select ‘Configuration Mode’ from the drop-down list at the top right corner.
2 Open the configuration that you want, using one of the ‘File’ menu options listed in
on page 156. To copy the current state of the Imagestore 750, select ‘File >
Open > From Device... > Active configuration’.
3 Make changes to the configuration as required.
4 Select ‘File > Save and Apply Configuration…’ from the menu.
5 Confirm the IP address of the target Imagestore 750, configuration filename, and that you
wish to proceed.
6 The Imagestore 750 restarts as a result of the ‘Save and Apply Configuration’ command.
The second method uses the front panel to import a configuration that has already been saved
on the Imagestore 750:
1 Select ‘User Presets > Import > filename.xml’ from the front panel menu.