Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 247)

231
Imagestore 750
User Manual
Disabled Disables slave command forwarding via the slave IP address.
Enabled Enables slave command forwarding via the slave IP address.
Slave type
Int-XG Dictates how store load/cue information is interpreted by the Imagestore 750
Not Int-XG Dictates how store load/cue information is interpreted by the Imagestore 750
Miscellaneous
Closed Cap
Disabled Allows keyed graphics to overwrite Closed Caption information in the active picture for NTSC
Enabled Preserves Closed Caption information in active picture for NTSC
Send Wakeup Sends a wake-up packet to all Oxtel protocol connections
File Ops The File operations are used for basic library management via USB. Network transfer will often
be preferred for management of image and sound files.
Load Image Loads all .oxt or .oxa images from the inserted USB media to the hard disk image library.
Erase Image Erases an image from hard storage
Load Audio Loads all .oxe, .oxw, or .wav sound files from the inserted USB media to the hard disk sound
library.
Erase Audio Erases a sound file from hard storage
Conf To USB Saves the active configuration file (config.xml) and GPI setup file (gpi.xml) to the inserted USB
media.
Conf From USB Copies a new configuration file (config.xml) and GPI setup file (gpi.xml) from the inserted USB
media. If a configuration file is successfully copied from USB, then a restart is advised.
Diags Save Copies the diagnostics file to the loaded media, including the log file from the current session
(messages) and log file from the previous session (messages.old)
Load Licences Copies new licence codes (syscodes.txt) from the inserted USB device, which enable software
options on the Imagestore 750 after a restart.
Load Mixfile Copies all .mix custom mixfiles from the inserted USB media to the hard disk mixfile library.
Erase Mixfile Erases a custom mixfile from hard disk.
Active Preview
Disabled Switches off active preview mode for Presmaster
Enabled Switches on active preview mode for Xpanel, Branding RCP or iMC panels
Self Tests
DSK 1
Image Border Displays a test pattern showing 4-pixel width colored borders
Animation Fill Loads a test animation and then runs the animation. Shows a continuously repeating progress
bar, and is used to verify correct installation of the store memory modules. Unload the self test
animation after completing the test.
DSK 2
Image Border See “DSK 1” above
Animation Fill See “DSK 1” above
DSK 3
Image Border See “DSK 1” above
Animation Fill See “DSK 1” above
DSK 4
Image Border See “DSK 1” above
Animation Fill See “DSK 1” above
EAS
Severity 1 Displays an EAS scrolling banner displaying ‘A Primary Entry Point System has issued an
Emergency Action Notification for the United States beginning at 1:27 pm and ending at 2:27
pm (IMST)’ at severity level 1
Severity 2 Displays an EAS scrolling banner displaying ‘The Civil Authorities have issued a Severe
Thunderstorm Watch for San Francisco, CA beginning at 1:31 pm and ending at 2:31 pm
(IMST)’ at severity level 2
Severity 3 Displays an EAS displaying ‘A Broadcast station or cable system has issued a Required Weekly
Test for Snohomish, WA beginning at 1:26 pm and ending at 2:26 pm (IMST) at severity level 3