Grass Valley Imagestore 750 v.3.0.1 - Manual (Page 248)

232
Prod Tests Enters Production Mode in which all functions of the Imagestore 750 halt. Warning: this must
NOT be used when the output is live on air. The production tests are not recommended for
general use; they are for hardware diagnosis only.
Soft Restart Causes the software to restart. Use this, for example, after changing a setting that requests a
restart (e.g. video standard). The system settings are restored after the restart depending on the
Active Configuration
Hard Restart Causes the hardware to reboot. A hard restart takes longer than a soft restart. The system settings
are restored after the restart depending on the Active Configuration
Factory Reset Resets the unit to the factory default configuration. Use this option with extreme care as all
custom set parameters will be removed.
Safe Shutdown Prepares the unit to be powered off. Use this command before removing power cables.
Test
Test Pattern
Off Switches off the test pattern signal for PGM OUT and PVW OUT
On Switches on the test pattern signal for PGM OUT and PVW OUT
Config Alarms
Ext Reference
Unlocked
Alarm Level Sets alarm level for ‘External Reference Unlocked’
Trap Enable Enables or disables the trap for this alarm
Mismatch
Alarm Level Sets alarm level for ‘External Reference Mismatch’
Trap Enable Enables or disables the trap for this alarm
A
Video Loss
Alarm Level Sets alarm level for ‘SDI A Video Loss’
Trap Enable Enables or disables the trap for this alarm
Video Mismatch
Alarm Level Sets alarm level for ‘SDI A Video Mismatch’
Trap Enable Enables or disables the trap for this alarm
Input Timing
Alarm Level Sets alarm level for ‘SDI A Video Input Timing’
Trap Enable Enables or disables the trap for this alarm
B
Video Loss
Alarm Level Sets alarm level for ‘SDI B Video Loss’
Trap Enable Enables or disables the trap for this alarm
Video Mismatch
Alarm Level Sets alarm level for ‘SDI B Video Mismatch’
Trap Enable Enables or disables the trap for this alarm
Input Timing
Alarm Level Sets alarm level for ‘SDI B Video Input Timing’
Trap Enable Enables or disables the trap for this alarm
C
Video Loss
Alarm Level Sets alarm level for ‘SDI C Video Loss’
Trap Enable Enables or disables the trap for this alarm
Video Mismatch
Alarm Level Sets alarm level for ‘SDI C Video Mismatch’
Trap Enable Enables or disables the trap for this alarm
Input Timing
Alarm Level Sets alarm level for ‘SDI C Video Input Timing’
Trap Enable Enables or disables the trap for this alarm