Grass Valley iMC-Panel-100 v.7.2.9.0 - Manual (Page 57)

45
iMC-Panel-100
Operator’s Guide (for Imagestore 750s)
The PS0001 power supply that comes with the iMC-Panel-100 has a 4-pin plug that goes in the
connector. The plugs are keyed so that you cannot insert the plugs the wrong way:
Connect the line cable to the power supply and then to AC power. Then insert the 4-pin plug
into the iMC-Panel-100’s power connector.
The button panel has two power connectors. You can connect an additional PS0001 for
redundancy.
Ethernet
The iMC-Panel-100 has one RJ-45 Ethernet connector. Connect the iMC-Panel-100 to the switch
on the master control network using CAT5 cable or better.
It is on this network that the iMC-Panel-100 communicates with MCPMs and with the configura-
tion software. You (or your system administrator) must provide a unique IP address for the iMC-
Panel-100.
Without the IP address, the iMC-Panel-100 cannot communicate with MCPMs, MCEs, or the
configuration software. Use the Panel ID menu under the Panel Menu to set the IP address and
IP subnet mask.
The default IP address is 192.168.7.100. and the subnet mask must always be 255.255.255.0.
S Operators generally need not be concerned with the iMC-Panel-100’s network address.
USB Ports
There are two USB ports. If your iMC-Panel-100 uses a Planar touchscreen, one of the USB ports
will connect to the USB port of the touchscreen. If your panel does not have a touchscreen, one
of the USB ports will be used for a mouse (with which you manipulate items on the display). The
other port is discretionary.
VGA Port
The VGA port (HD15) connects to the VGA port of the display.
GPI/Alarm
The iMC-Panel-100 has a DB25 connector that supports GPI inputs, GPI outputs, and alarms:
2
1
4
3
Receptacle
n.c.
n.c.
GND
12VDC
4
3
2
1
GND
12 VDC
n.c.
n.c.
Plug
13 1
14 25
Minor Alarm
GPI In 1
unused
GPI Out 1
Major Alarm
unused
GPI Out 2
GPI In 2
11
23
10
COM
NO
NC
8
20
7
GND
–
+
5
17
4
COM
NO
NC
2
14
1
25
12
24
COM
NO
NC 22
9
21
19
6
18
GND
–
+
16
3
15
COM
NO
NC