Saving dsk settings, Working with dves – Grass Valley iMC-Panel-100 v.7.2.9.0 User Manual
Page 139
127
iMC-Panel-100
Operator’s Guide (for Imagestore 750s)
Saving DSK Settings
Press ‘Options Saving’ to access a sub-menu in which to save settings for the specific DSK: rate,
the clip, gain, transparency parameters, or key options. The ‘Options, Saving’ sub-menu appears:
Fig. 6-3: DSK Options Saving Page
Then press ‘Save DSK Settings’ to save the settings. Note that this button is absent if you have
cleared the DSK because there are no settings to save.
Working with DVEs
There are up to 4 DVE buttons on the panel. The Imagestore 750 configuration permits the asso-
ciation of one DVE (of a possible 97 stored DVEs) with each button.
S
The LGK-3901, DSK-3901, and ISM-3901 do not provide DVEs. When panels controlling these
units have DVE buttons, the DVE buttons are disabled.
To use a DVE:
1 Press the appropriate DVE button on the preset row.
2 Carry out other presets as required.
3 Press the transition button.
You can “hot cut” DVEs to the program bus. Hot cuts are not recommended.
If your panel has a ‘PGM DVE Enable’ button, you can use it to enable or disable DVEs on the
program bus.
If your panel has a ‘PST DVE Enable’ button, you can use it to enable or disable DVEs on the
preset bus.
The use of DVEs is affected by certain transition options. See
more information.