Grass Valley iMC-Panel-100 v.7.2.9.0 - Manual (Page 48)

36
Control Panel
Functional Sections of the Panel
Voice-Over Source Status
The touchscreen displays an over’s source status. These are the fault conditions:
If status is “OK,” there will be no message.
The third line of text displays “CUT” or “FADE” depending on how the over was armed. If the
effect is not armed, the third line of the button is blank.
Bottom Row Buttons
These buttons are all configurable:
The configurable button functions are described under Definable Button Functions , on page 37.
Transition Button
Pressing the transition button initiates a transition in the Imagestore 750 controlled by your
panel. You can change the transition rate and type.
The transition button is orange under normal circumstances. The transition button is high-tally
while the Imagestore 750 is performing a transition. Otherwise it is low-tally.
The maximum transition period is 999 frames. The minimum is 1.
When you press this button, the panel sends a transition request to the Imagestore 750.
Please note the following points regarding transitions:
• You can start a new transition only after the current transition has completed.
• You can always interrupt a transition in progress with a cut on the program bus.
• Fade transitions (cut-fade, V-fade, U-fade, and fade-cut, and others) involve a fade to black
during the transition.
1 LOS
2 Problem