H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 58
48
3.
Set the operation parameters for the port, as described in
4.
Click Apply.
Table 14 Configuration items
Item Description
Port State
Enable or disable the port.
Sometimes, after you modify the operation parameters of a port, you must disable and
then enable the port to have the modifications take effect.
Speed
Set the transmission rate of the port.
Available options include:
•
10—10 Mbps.
•
100—100 Mbps.
•
1000—1000 Mbps.
•
Auto—auto-negotiation.
•
Auto 10—auto-negotiated to 10 Mbps.
•
Auto 100—auto-negotiated to 100 Mbps.
•
Auto 1000—auto-negotiated to 1000 Mbps.
•
Auto 10 100—auto-negotiated to 10 or 100 Mbps.
•
Auto 10 1000—auto-negotiated to 10 or 1000 Mbps.
•
Auto 100 1000—auto-negotiated to 100 or 1000 Mbps.
•
Auto 10 100 1000—auto-negotiated to 10, 100, or 1000 Mbps.
Duplex
Set the duplex mode of the port:
•
Auto—auto-negotiation.
•
Full—full duplex.
•
Half—half duplex.
Link Type
Set the link type of the current port, which can be access, hybrid, or trunk. For more
information, see "Configuring VLANs."
To change the link type of a port from trunk to hybrid, or vice versa, you must first set its link
type to access.
PVID
Set the default VLAN ID of the interface. For more information about setting the PVID, see
"Configuring VLANs."
To make sure a link properly transmits packets, the trunk or hybrid ports at the two ends of
the link must have the same PVID.
Description
Set the description of the port.